the TOP LID however i print at a layer height of 0.285 to get an accurate finish. I print these with a 0.6 nozzle at 0.3 layer height, 0.4 nozzle will be fine too. STLBase is a Search Engine for 3D printable Models and STL Files. Print the PULL OUT MODIFIER DECK upright, you'll get the best detail and speed out of it. Three easy to print files and you've got your own dashboard :) Pull this Dashboard out and be setup in under 30 seconds! The cardboard boxes that the characters come in are fine, but not meant for repeated use. It has by far been one of the best upgrades for Gloomhaven i have made, alongside my custom health counter shown in the pictures. The lid can also be used to display items, collect coins, hold the modifier deck and also house my custom Health and Experience Tracker The PULL OUT MODIFIER DECK is just a simple solution and a place to keep the modifiers, i personally like to place it on the lid after unpacking. The TOP LID slides into place and locks with a slight click to prevent the small pieces escaping, Apply a tiny amount of grease or lube of your choice on the sides and it will slide in perfectly. I've created a small dish for the players tokens, a slightly larger one for extra tokens/summons/coins and then 3 slotted recesses for active effects on the player, like muddled or stunned. The player card being used as the table on which you set your cards out as pictured, the two slots either side that act as holders for your discard/lost cards and then the top part of the tray being used for active cards that round. The MAIN TRAY houses everything from the mini to the tokens, with enough slots and holes to use in any way you feel more comfortable. This time, blending both a storage solution, and a comprehensive Dashboard to keep track of all your bits! Check out the link for a video of it in use! I didn't like any other dashboards around for Gloomhaven, so I made my own. ***BEST FOR A FDM (FILAMENT) PRINTER ONLY***
0 kommentar(er)
